Double Tube Light Connection With Electronic Choke. Most of the year i do not need a choke it was 105 here friday don t need a choke then so i would not need power then. Here two tube lights are used in our case each one is 20 watts each tube light will have two filament with four terminals connect starter element to any on side of tube light after that link phase line to the ballast choke through switch.
I have a question about the electric choke. However there are winter days in the 20 s when a choke would be nice. If the tube does not sufficiently charge up subsequent kicks are delivered by the choke due to rapid switching of the starter so that finally the tube strikes.
After this the choke only acts like a low impedance current limiter to the tube as long as the light is kept illuminated.
This article gives a details about double tube light connection by using single ballast or choke some electronic choke not support this connection check the ballast specification and watts level before make this type of connection. At this point the ballast or choke kick s back it s stored current which again passes through the filaments and ignites the tube light once again. However there are winter days in the 20 s when a choke would be nice. If the tube does not sufficiently charge up subsequent kicks are delivered by the choke due to rapid switching of the starter so that finally the tube strikes.